Which of these does OSHA require employers to construct and install to minimize electrocution hazards?


Answer 1


OSHA requires that the exposed and operating elements of an electrical installation, lighting, equipment, motors, machines, appliances, switches, controls, and enclosures must be constructed and installed so as to minimize workplace electrocution hazards.

Related Questions

Explain how metal is produced and turned into a product e.g. bed



the metal is mined from mines and melted to make objects

The ratio of boys to girls in the class was 2 to 3. If there were 18 girls in the class, how many students were in the class


37 students in the class
18 Girls and 19 Boys

during a load test, a battery's voltage drops below a specific value. what action should the technician take?

A. Recharge and retest.
B. Allow battery to become fully discharged and retest.
C. immediately replace
D. None if above





allow battery to become fully discharged and retest

When fully charged, a normal 12-volt automotive battery will have about 12.6 volts. The voltage just needs to fall to about 10.5 volts to be deemed fully discharged. The battery will suffer harm owing to severe sulfation if it falls below that level. Thus, option B is correct.

What battery's voltage drops below a specific value?

Changes in Voltage Occur During Discharge, The voltage of each cell is approximately 2.5 to 2.7 volts before the charging circuit is opened at the conclusion of a charge. The voltage of the cell rapidly reduces to roughly 2.1 volts within three or four minutes of the charging circuit being opened.

The voltage across the battery terminals decreases if a load is connected across the battery. The battery's internal resistance is to blame for this voltage drop. By measuring the open-circuit voltage and the voltage across the battery's terminals when a load is connected, we can determine the internal resistance.

Therefore, allow battery to become fully discharged and retest should the technician take.

Learn more about battery's here:



LIST the differences between softwood and hardwood



Hardwood is usually denser than softwood.

Softwood is cheaper than hardwood.

Hardwood has good fire resistance while softwood has poor fire resistance.

Softwood is lighter than hardwood.



Other Questions
what will happen if all snakes are killed Most chemical reactions within cells do not occur spontaneously. Instead, they need a catalyst to get them started. Why do you think this is so? Evaluate the expression. 0.3 = -5 - (-0.4 - -0.6) Write your answer as an integer or a decimal. Do not round. The gradient of the line joining (4, q) to (6, 5) is twice the gradientof the line joining (0, 0) to (4, q). Find q. (fg) (x) (4x+8)(2x-12) guys help i need this 100 what are lower and higher energy levels. 1. What happens when matter changes state?a. Its chemical properties change.b. Its physical properties change.c. The energy of its particles remains the same. haped. two of the above Can someone help me out? what word is spelled correctly,Saint,I,Mom,Weekday Dosage Instructions Days' Supply Needed2 tablets, 2X per day 28Tablets Per Bottle55 Angle AOE has what measurement according to the protractor?A. 140B. 60C. 40D. 120 5x = yidentify the slope and y intercept for the line set up own sentence in phrasal verbs IM TIMED PLS HELP :)Use context clues to find the definition for the word tributaries as it used in these sentences.any bodies of water in the United Statessmall streams of watersmaller rivers that flows into a larger riverthe rivers found near the Mississippi How should we utilise the landform of Nepal for economic progress of the Nation? Suggest any seven point What are the potential solutions of In(x2 - 25) = 0?Ox= 113O x= 15x=+26Ox=+10 What is the value of 2-3. 22,Pls help quick a man bought a 4 kg apples at the rate of rs 50 per kg he sold 3 kg apples at the rate of rs 65 and 1 kg apples at rs 40 find his profit or loss amount. How much time does a train take to travel1800 km if it's velocity is 90km/hr